Mini Extra Instruction Addendum

These are the differences between the original 32” Extra kit build instructions and the Mini Extra kit.

The mini kit is 6mm EPP rather than the 9mm of the 32” kit.

The flat carbon strips are 5mm rather than 7mm and the pushrods are 1.3mm rods rather than 2mm rods.

the motor (used in our completer) is mounted with 3 screws. When you glue the plywood disk into the fuselage, align the wires with the lower quadrant where the radio equipment will be located. This is easiest if you mount the screw in line with the notch to the bottom.